- Allowed Pattern Width
This rule checks whether nets keep allowable trace widths.
- 3D Clearance
- Antenna Via
- Bus
- Bus2
- BUS (T-Topology)
- Component to Net Clearance
This rule checks for component clearance violations when routed traces may affect the performance of nearby components.
- Confirm Net Group
This option helps engineers to visually differentiate specific classes of nets or net groups from the rest of nets, and identify nets with more or less than the specified number of connected components.
- Connected Comp
This rule checks for the proper use of special purpose components.
- Connected Circuit
This rule checks for the validity of circuit usage and whether the routing length and clearance from driver pins are within the specified distance.
- Copper Area Ratio
This item checks for copper area ratio on each layer.
- DC Resistance
In high power system the designer should check trace resistance in order to avoid IO-Drop problem. This rule calculates trace resistance.
- GND Isolation
- Length
This rule checks for a trace length violation.
- Trace Length in PCB
- Transmission Line Basics
- Limit Approach Net
This rule checks whether two nets are within a specified distance.
- Net Loop
This item checks whether the net has formed a loop.
- Net Group Shield
This item checks for a shielding ratio of bus group.
- Net Isolation
This item checks net connection between start pins to end pins.
- Net Self Coupling
This item checks whether the same net is placed close together.
- Net to Net
This item checks whether a specified clearance requirement for the net is satisfied.
- IPC Material
- Passive Device Stability
This item checks whether the filter installed in the IO terminal is well designed with low impedance.
- Pattern Sharp Angle
This rule searches for routing angles that are sharper than the specified reference angle.
- Prohibited Connected Comp
This item finds components that should not be connected to certain signals.
- Serpentine
This item checks all symmetry items for uniformity of the differential pairs design environments.
- Star Connection
This rule checks whether power pin connected to decap via separation path to form a Star Connection.
- Stub
This stub rule checks unnecessary stubs for specific use cases.
- Test Point
This rule checks the test point/via number and clearance of net.
- Net Topology
This item checks whether the topology required for design is used.
- Via Quantity
This item checks layers change by counting the number of Vias used in a signal net.
- Width
This rule checks routed trace widths against the specified minimum or maximum allowable widths.
