Home
Boundary Conditions
Boundary Conditions available for SimSolid.
Perfect Electric Conductor (PEC)
Apply perfect electric conductor condition to faces.

Welcome
What's New
View new features for SimSolid 2026.
Get Started
Learn the basics and discover the workspace.
Tutorials
Discover SimSolid functionality with interactive tutorials.
Interface with External Products
Interfaces that support SimSolid output file format.
Geometry
Information about treatment and properties of geometric entities in SimSolid.
Assembly
Summary of available functionality for defining the properties and behavior of parts in the model.
Connections
Connections are used to define the association of different regions of interest between parts in an assembly.
Create Analysis
Create an analysis for your project.
Boundary Conditions
Boundary Conditions available for SimSolid.
- Available Boundary Conditions for Analyses
  A comparison chart showing the available boundary conditions for each analysis type.
- Constraints
- Pressure
- Force/Displacement
  Apply uniform loads and/or displacements to faces, edges, vertices, or spots.
- Gravity Load
  Simulate the force of gravity as it affects your model.
- Translational Inertia Load
  Apply a uniformly distributed translational inertia load over the volumes of the parts in an assembly.
- Rotational Inertia Load
  Apply a uniformly distributed rotational inertia load over the volumes of the parts in an assembly.
- Inertia Relief
  Simulate deformations and stresses in cases where you have an unconstrained structure to which an active load is suddenly applied.
- Remote Load
  Apply distributed loads (tractions) to faces, general virtual connector, or spots that are statistically equivalent to a load applied on a single point.
- Remote Displacement
  Apply displacements to faces and/or spots that are statistically equivalent to a load applied on a single point.
- Thermal Load
  Simulate deformations and stresses induced by the temperature changes in your model.
- Bearing Load
  Apply a varying pressure load to full or partial face(s) of revolution.
- Distributed Mass
  Apply distributed mass across selected faces.
- Bolt/Nut Tightening Loads
  Available for blind bolts (bolt without a nut), bolt with nut/bolt on threaded rod, nut on generic post or handle.
- Base Excitation
- Volume Expansion/Shrinkage
  Apply volumetric expansion/shrinkage coefficient over seam welds or other parts in the assembly.
- Temperature
  In thermal analysis, limit temperature on the selected faces, edges, vertices, or spots to a prescribed value.
- Thermal Convection
  In thermal analysis, define a convective heat exchange condition on faces and spots.
- Surface Heat Flux
  In thermal analysis, apply uniformly distributed heat loads to faces and spots.
- Volume Heat Loads
  In thermal analysis, simulate internal heat generation and internal heat absorption in volumes.
- Solar Loads
  Apply heat loads based on the sunbeam’s direction for thermal analysis
- Perfect Electric Conductor (PEC)
  Apply perfect electric conductor condition to faces.
- Waveguide Port
  Specify the excitation planes in waveguide structures.
Post Processing
Run analyses and view a variety of results in SimSolid.
Design Study
Design studies allow you to quickly evaluate and compare the structural performance from different design scenarios.
Verification Problems
Solved verification models.
Frequently Asked Questions
This section provides quick responses to typical and frequently asked questions regarding

Perfect Electric Conductor (PEC)

Apply perfect electric conductor condition to faces.

In the Project Tree, open the Electromagnetic Analysis Workbench.
In the workbench toolbar, click the (Perfect Electric Conductor) icon.
In the modeling window, select specific faces from the model.
Click OK.