| Interaction |
|
| Surface Interaction Name |
To be specified by the user and refer in the
contact definition below |
| Friction |
User have to enter the friction co-efficient
value. |
| Contact |
|
| Method |
Body / NodeSet / ElemSet / Group |
| Master |
Master Body / NodeSet / ElemSet / Group name
/ GROUP_NUMBER_TEMPLATE |
| Slave |
Slave Body / NodeSet / ElemSet / Group name /
GROUP_NUMBER_TEMPLATE |
| CONTACT TYPE |
Standard/ Rough / No separation (sliding
permitted) / Bonded /No separation (always) / Bonded (always) /
Bonded (initial contact) |
| Tolerance |
Auto or User has to enter the tolerance
value |
| Contact Face Type |
Cylindrical / Planar / All |
| Trim |
NONE / SLAVE / Slave and Master |
| Contact algorithm(K2) |
Augmented Lagrangian / Penalty function /
Multipoint constraint / Lagrange multiplier / Pure Lagrange
multiplier |
| Contact detection point(K4) |
Gauss point / Nodal contact normal / Nodal
target surface / Nodal projection based) |
| CNOF/ICONT auto adjustment(K5) |
No automated adjustment / Close gap with auto
CNOF / Reduce penetration with auto CNOF / Close gap or reduce
penetration with auto CNOF / Auto ICONT |
| Elem level time inc control(K7) |
No control / Automatic bisection of increment
/ reasonable time/load increment / minimum time or load
increment / Use impact constraints |
| Effect of initial penetration or
gap(K9) |
Include / Exclude / Include with ramp /
Offset only / Offset with ramp |
| Real Constant |
|
| RC"Number" |
value of real constant |
| RC1 |
5.123 |
