vovwxconnect

vovwxconnect: Usage Message

DESCRIPTION:
    Utility to setup a connector for Accelerator Plus to a primary queue

OPTIONS:
    -h               -- This help.
    -v               -- Increase verbosity.
    -nc NCQ          -- Connect with specified Accelerator queue.
    -vovdir PATH     -- Specify VOVDIR for the Accelerator queue, if different
                        than that of Accelerator Plus.
    -ncconfigdir     -- Specify NC_CONFIG_DIR for the Accelerator queue, if
                        different than that of Accelerator Plus.
    -lsfemul NCQ     -- Connect with Accelerator but using the LSF emulation
                        interface (only for debugging)
    -dd              -- Connect with Direct Drive
    -pbs             -- Connect with PBS
    -pbsemul NCQ     -- Connect with Accelerator but using the PBS emulation
                        interface (only for debugging)
    -legacy          -- Connect using legacy daemons vovelasticd vovlsfd.
    -show            -- Show what is connected.
    -test            -- Validate connections by running a test job.
    -nostart         -- Do not start the vovwxd daemon.
    -loglevel L      -- Set verbosity level for vovwxd (0-6)

EXAMPLES:
   % vovproject enable MY_WX_PROJECT
   % vovwxconnect -nc vnc1 vnc2
   % vovwxconnect -nc vnc1 -nc vnc2
   % vovwxconnect -nc vnc_test -vovdir /some/path/to/a/vovdir/used/by/vnc_test
   % vovwxconnect -pbs
   % vovwxconnect -show
   % vovwxconnect -test
   % vovwxconnect -lsfemul vnc_test