Modulation and Coding (TDMA)

Modulation and Coding Schemes (MCS) for TDMA Systems

A list with all currently defined MCS can be found at Project > Edit Project Parameter and click the Air Interface tab. Further transmission modes can be defined, existing ones can be adapted during the planning process. The defined transmission modes can be sorted considering various criteria. The order of the MCS does not influence the simulations but the sequential arrangement in the Tree View and on the dialogs.

The following dialog shows the parameters which define a transmission mode of a TDMA system in ProMan. The settings can be specified for the downlink (BS to MS) and the uplink (MS to BS) direction separately.

Name

Arbitrary name for transmission mode.

Direction to be analyzed

Downlink and uplink directions can be analyzed individually for each transmission mode. Accordingly it is possible to analyze transmission modes for Only Downlink or for Only Uplink without impact of the other direction.

Consider mode during simulation

If this option is enabled, the transmission mode will be considered during network planning simulation. Transmission modes which are specified to be not considered during simulation are display with red text color in the Transmission Modes (MCS) list.

Position of mode in simulation sequence

The position (priority) of the transmission modes affects the throughout results as the transmission modes are analyzed according to their position value. Typically the networks are configured to maximize the throughput. For this purpose the transmission mode with the first position should be analyzed first. If there are some radio resources remaining then the transmission mode with the second position will be analyzed for checking if the throughput can be further increased and so on. So to maximize the throughput, the transmission modes should be assigned reasonable values for the position. Without this sorting it might happen that transmission modes with low data rates use the available radio resources and thus the maximum throughput is not exploited.

Note: It is not possible to have multiple transmission modes with the same position in simulation sequence. The individual positions of the transmission modes do not have to be consistent (gaps are possible).

Data Transmission Parameters (for downlink and uplink)

Modulation

Modulation scheme used for data transmission.

Code rate

The code rate states the portion of the total amount of information that is useful (that is non redundant). If the code rate is k/n, k bits out of n totally generated bits are useful information, whereas (n-k) bits are redundant. The redundant bits are used for error detection and correction.

Nr of Timeslots

Number of time slots, which can be used for this transmission mode.

Overhead ratio

Ratio between gross and net data rate.

Data rate (read only)

Net data rate, which is automatically computed according to the parameters specified above.

Radio Parameters (for downlink and uplink)

Minimum required SNIR

Minimum signal-to-noise-and-interference-ratio, which is required to use this transmission mode. Receiver locations, where the predicted SNIR is above this threshold will be assigned to this transmission mode and the maximum available data rate for the corresponding Rx locations will be set to the value specified for this MCS.

Minimum required Signal Level (optional)

Optional threshold of signal level, which is required to use this transmission mode.

Note: The specified minimum signal level for the uplink direction refers to the input of the base station receiver and not to the power received directly at the antenna. In case a cable loss is defined, the received power at the antenna is additionally reduced by the cable loss before it is compared to the specified minimum required signal level.

Tx power backoff

Power headroom which can be specified related to maximum available transmit power of the base station (for downlink direction) or the mobile station (for uplink direction), respectively. This headroom can be used to reduce available transmission power and therefore crosstalk probability for high modulation and coding schemes.

Note: This back off value influences only the transmit power used for data transmission. The power assigned for pilot signals is not influenced.