Chamfer on edge
Introduction
The operation Chamfer on edge permits the user to machine the edges of the objects by:
 An equal distance to apply on the two adjacent faces
 Two different values of the distances on the two adjacent faces
Equal distances  Different distances 

Structure of a chamfer on edge
The operation of Chamfer on edge is decribed by:
 A coordinate system for the creation of points (active coordinate system in the list available on the graphic View)
 A list of entities on wich the chamfer should be applied
 A type of Edge chamfer (equal distances or different distances)
 The distances to apply
Dialog box  Illustration 

List of entities
The operation Chamfer on edge is applied on the lines of Flux project. It is possible to select:
 points : the chamfer is applied on all the lines connected to the selected points
 lines : the chamfer is applied on all the selected lines
 faces : the chamfer is applied on all the lines of the selected faces
 volumes : the chamfer is applied on all the lines of the selected volumes
 objects : the chamfer is applied on all the lines of the selected objects
It is possible to mix the types of entities for the same chamfer operation.
Result
The creation of a Chamfer on edge has as results:
 A geometric operation CHAMFER_1.
 The addition of this geometric operation in the list of geometric operation of each of the impacted objects.
Access
The different ways to acces the operation Chamfer on edge are:
 By menu:
 By icon:
Creation of a chamfer on edge
The creation process of a chamfer on edge is presented in the table below.
Stage  Description 

1  Choice of the coordinate system of creation 
2  Opening the dialog box Chamfer 
3 
Choice of the name of the generated Geometric operation (by default: CHAMFER_1) 
4 
Choice of entities on which the Chamfer will be applied
or
or

5  Choice of the type of chamfer (equal distances or different distances) 
6  Choice of the distance or of the two distances to apply 
7  Validation by clicking on OK 
→  A geometric operation CHAMFER_1 is created 
Limitations
Few limitations:
 While editing the geometric operation, the list of entities on which the chamfer is to be applied cannot be modified. Only the distance (or the distances) are modifiable
 No preview of the chamfer is available in modification