Winding - Overview

Please refer to the user help guide dedicated to the “Windings” design for more detailed user information.

For all types of winding, whether polyphase, three-phase classical or hairpin, the home page characteristics are the same. The following picture illustrates the main areas of the home page which is displayed for the classical winding.

WINDING design area - Overview
1 Selection of the STATOR subset: WINDING panel (Click on the icon WINDING)
2 Once a winding is defined, corresponding results are automatically displayed in form of a winding report. Visualization of the winding characteristics (inputs, settings, materials, etc) is possible.

Scrollbars allow browsing the whole document rapidly and having an overview of all the results.

Using scrollbars, complete data can be accessed and visualized.

3 Shortcuts for displaying the corresponding chapter of the winding report.
4 Winding settings allow describing the winding architecture.
5 Winding settings allow describing the winding:

Choice of the winding connection: Y (Wye) or Δ (Delta).

(Only available for 3-phase winding, polyphase winding is always connected in star connection)

7 Four modes allow defining and building the winding architecture .
Auto Automatic mode used by default.
Easy Easy mode, to choose solution among what is proposed.
Adv. Advanced mode, to allow the user to define his own input parameters.
Expert Expert mode to set the connection table.
8 User input parameter field to enter the value according to the considered mode.

Scrolling selection bar – Winding environment
1 Selection bar where Winding, Coil, End-winding and X-Factor sections can be selected
2 Section data can be reached thanks to shortcuts
Note: This mode of section selection is applied for both type of windings: 3-phase and polyphase.