- 1 Pin Nets
Scan the Net List on PCB data and detect the net which is connected to only 1 pin.
- Acute Angle
Check the Angle formed by objects and segments
- Connected Pad
This section examines whether the ratio of the connection of pad and pattern is outside the defined value.
- Connected Pattern Direction
Check the pattern opposite routed directions.
- Copper Boundary Width
Checks the outline width of copper-pour data.
- Crack Pattern
In almost cases, pattern connected to pin should be thicker than a certain width and should keep its thickness within a certain distance.
- Intermediate Pattern
Check the thickness which deviates from the pad edge.
- Keep Out Pattern
Check routing status from certain components.
- Lines Between Two Pins
Check the number of patterns, the distance between pins, and the distance between pin and patterns.
- Mechanical Short
Check an electrical short of different routing patterns.
- Min Same Net Spacing and Width
Check the minimum spacing between copper objects and the copper width.
- Minimum Width
Check the pattern minimum width.
- Net to Net
Check the clearance between net to net.
- Object to Object
Wiring designed by Artwork mode is recognized as objects and not nets, but it is required to keep the clearance between object to object.
- Pad to Net
Check a component pin clearance with various objects on design.
- Silver Paste TH PCB
In the case of a PCB design designed to use silver paste, it can be checked with the related design rule here.
- Unrouted Net
This item can detect the dangling net and check the connected net to see if the net is completely connected to pin or not.
- Void Coverage
Check the void coverage with hole placed to copper plane.
