- Antenna Ground
- Connected Via
This item checks for the distance from a pin to via.
- Decap
This rule checks for the number of capacitors per each PWR/GND pin to help the designer to determine the stability of IC component’s power supply. The rule also reports the distance between capacitor and IC components.
- Decap2
This rule checks a design guide for decoupling capacitor usage.
- Electrical Conductor Spacing
This feature allows precise inspection and verification of the spacing between electrical conductors on printed circuit boards (PCBs).
- Ground Coverage
This item checks for via locations and via area coverage.
- Inductance
This DFE rule is to check the trace length from passive component to GND.
- Power-Net to Net
The rule checks whether two power traces have enough spaces.
- IPC Material
- Parallel Jumper
This DFE rule is to check the required jumper count.
- Potential Difference
This DFE rule is used to compare net clearance and capacitor voltage with a voltage standard table.
- Power-Width
This DFE rule checks routed pattern trace widths compared to specified minimum and maximum widths.
- Stability Copper
This DFE rule searches isolated copper patterns.
- Supplementary Pattern
This DFE rule is to check that the total trace width meets the requirement if there is branch.
- Via Option
This DFE rule is to check the number of power trace via.
