Component Tab

Modify contents of Net Group using component pins.

This method is almost the same as the Component Pin sub-menu in the Classification Tab.

  1. Select a Component Group.
    All pins are listed in a pin name table.
  2. Select required pins from the pin name table.
  3. Click Set Net Group.
  4. In the Net Group List dialog, select the required Net group.
  5. Click OK.
    All nets connected to the selected pins are automatically added to the selected Net Group.
  6. Click Classification tab to confirm and select DDR_CNTR Net Group.
    As an example, in the figure below, pin L1 and L2 are added to DDR_CNTR Net Group.
  7. Click Delete Net Group to delete some pins from all predefined Net Group contents.