Cutting and extending the lines
Introduction
In order to help the user in the geometry definition, especially to avoid defects in the construction of the lines, some facilities are provided by Flux PEEC. They are available as icons in the toolbar and as commands in the menu
.These four facilities are described in the following blocks:
 cut line on point
 cut two lines at their intersection
 extend line to point
 extend line to line
Cut line on point
To cut a line on a point:
Step  Action 

1  In the menu Cut line on point.  click on the command
→  A dialog box Cut line on point is open. 
2 
Fill in the fields:

3 
Validate the information by clicking on OK 
→  The line is cut into two. 
Cut two lines at their intersection
To cut two lines at their inters ection:
Step  Action 

1  In the menu Cut two lines at their intersection.  click on the command
→  A dialog box Cut two lines at their intersection is open. 
2 
Fill in the fields:

3 
Validate the information by clicking on OK 
→  The two lines are cut. 
Extend line to point
To extend a line to a point:
Step  Action 

1  In the menu Extend line to point.  click on the command
→  A dialog box Extend line to point is open. 
2 
Fill in the fields:

3 
Validate the information by clicking on OK 
→  The line is extended. 
Extend line to line
To extend a line to another line:
Step  Action 

1  In the menu Extend line to line.  click on the command
→  A dialog box Extend line to line is opened. 
2 
Fill in the fields:

3  Validate the information by clicking on OK 
→  The line is extended. 