PolyQuadBall

Create and edit a "nurbified" polygonal quadball.

Create a PolyQuadBall

Create a "nurbified" polygonal quadball.

  1. On the ribbon, click the PolyNURBS tab.
  2. Click the PolyQuadBall icon.
  3. Drag to draw the quad ball, and then release to set the diameter.
  4. Optional: See Step 2 of Edit a PolyQuadBall.
    Note:

    This is only available at this point during the creation. It is not available later (i.e after you create the cube and come back to edit).

  5. Right-click and mouse through the check mark to exit, or double-right-click.

Edit a PolyQuadBall

Resize and change the number of subdivisions in a polygonal quadball.

  1. Edit the polyquadball:
    To Do this
    Change the diameter
    • Drag the diameter.
    • Click the text box along the diameter, and then enter a value.
  2. Right-click and mouse through the check mark to exit, or double-right-click.
    Note: These parameters are only available in creation phase.