Pattern

In the Pattern tab, add the Sub Call and set the patterns of each Sub Call.

  1. Base Location of Sub Call
    The nozzle movement coordinate pattern can be managed with multiple sub calls. For example, if the underfill needs to be applied twice with intervals, the sub call should be registered into two separately.
    1. Base Location X/Y: Indicate the coordinates of the base location set in the General tab.
    2. Sub Call List: Display the list of registered sub calls.
      • Sub Call Name: Enter the name of the sub call.
      • Sub Weight (mg): Display the amount of the underfill applied in the corresponding sub call. When setting the nozzle coordinate data, it is displayed by automatically summing the applied weight.
    3. Add Sub Call: A new sub call is created in the table.
    4. Delete Sub Call: Delete the selected sub call.
  2. Sub Call Pattern: Set the coordinate pattern to move the nozzle of the underfill dispenser in the sub call.
    1. Sub Call: Select the sub call to register the pattern.
    2. Table
      • No: Display the pattern number.
      • Command: Set the nozzle movement command.
        • MOVE: Move the nozzle and moving speed and height of the nozzle is set through parament selection, which displays as a dotted line.
        • DOWN MOVE: Move the nozzle down to the specified height and moves to the height of the selected parameter.
        • UP MOVE: Move the nozzle up to the specified height and moves to the height of the selected parameter.
        • W LINE: Apply the underfill solution to the specified weight while moving the nozzle,which displaysas a solid line.
        • LINE: Apply the underfill solution while moving the nozzle, which displays as a solid line.
        • BAD MARK: The entered coordinates are registered as the bad mark.
      • Head: Display the head information of the underfill dispenser.
      • Parameter: Specify the parameter for the current pattern command.
      • This is the setting value for the moving speed and height of the nozzle.
      • X,Y Location: Display the X/Y coordinates of the nozzle to be moved.
      • Set Location: Set the coordinates of the nozzle directly to be moved.
      • Weight (mg): When the command is set to the W Line, enter the amount of underfill solution.
    3. Move Up: Move up the selected pattern position in the list.
    4. Move Down: Move down the selected pattern position in the list.
    5. Add Pattern: Add a new pattern in the list.
    6. Delete Pattern: Delete the selected pattern in the list.