Define ultraFluidX Mesh Controls

Use the ultraFluidX Mesh Controls dialog to define mesh settings.

1. From the ultraFluidX ribbon, Setup group, click the Advanced meshing parameters tool.

   
   
   Figure 1.

   The ultraFluidX Mesh Controls dialog opens.
2. In the ultraFluidX Mesh Controls dialog, define the desired mesh controls settings.

   Triangle plinth

   Create a plinth surface around single voxel gaps near the wind tunnel ground.

   Triangle splitting

   Activate triangle splitting of surfaces.

   If Triangle splitting is enabled, the following edge length controls apply:

   Maximum relative edge length

   Triangle edge length relative to the local voxel size.

   Maximum absolute edge length

   Maximum triangle edge length.

   Far field element size

   Coarsest element size.

   Refinement level transition layers

   Minimum number of elements to create between mesh refinement zones.

3. Click Close.