Elbow
Elbow
Library
HydraulicsByFluidon/Components/Lines
Description
The component Elbow is a valid model for Elbow angle between 30° and 120°.
Please consider: The component was modeled in order to consider the pressure losses of sharp edged elbows. However, the use of the component can lead to extremely long simulation times, since a small stepsize must be selected due to the low resistance of an elbow.
Formulas are taken from W. Wagner, Strömung und Druckverlust, 7. Auflage 2012, and Will, D., Hydraulik, Grundlagen, Komponenten, Schaltungen, 5. Auflage 2011.
Parameters
| Name | Label | Description | Data Type | Valid Values |
|---|---|---|---|---|
mo_Diameter | Diameter | Diameter | Scalar | |
mo_Angle | Angle | Elbow angle | Scalar | |
mo_deadVolume | deadVolume | Dead volume at ports | Scalar | |
mo_enableZetaOutput | enableZetaOutput | Enable zeta output | Number | 0 |
mo_enableReOutput | enableReOutput | Enable Re output | Number | 0 |
mo_pA | pA | pA | Structure | |
mo_pA/fixed | fixed | Cell of scalars | true | |
mo_pA/start | start | Cell of scalars | ||
mo_pB | pB | pB | Structure | |
mo_pB/fixed | fixed | Cell of scalars | true | |
mo_pB/start | start | Cell of scalars |
| Name | Label | Description | Data Type | Valid Values |
|---|---|---|---|---|
mo_forwardFluidProperties | forwardFluidProperties | Forward fluid properties between ports | Scalar | true |
| Name | Label | Description | Data Type | Valid Values |
|---|---|---|---|---|
mo__nmodifiers | Number of Modifiers | Specifies the number of modifiers | Number | |
mo__modifiers | Modifiers | Add new modifier | Structure | |
mo__modifiers/varname | Variable name | Cell of strings | ||
mo__modifiers/attribute | Attribute | Cell of strings | 'start' | |
mo__modifiers/value | Value |
Ports
| Name | Type | Description | IO Type | Number |
|---|---|---|---|---|
fluidPortA | implicit | Hydraulic port A | input | 1 |
fluidPortB | implicit | Hydraulic port B | input | 2 |
Port 3 | implicit | Zeta | output | mo_enableZetaOutput |
Port 4 | implicit | Re | output | mo_enableReOutput |