Automatic Distribution of Nodes

Distribute nodes stochastically within the simulation environment.

A stochastic distribution of nodes is useful if their exact position is unknown because they have been placed randomly in order to monitor large areas for example. CoMan offers the possibility to randomly distribute transceiver nodes over the whole simulation area either using a fixed number of nodes, a homogeneous distribution density or based on land usage maps with a density value for each land usage class.

The Node Distribution function can be accessed via Project > Object > Distribute Automatically in the Project menu.

Note: This option is available for rural simulation scenarios only.

Distribution Settings

Different options are available for distributing nodes within the simulation environment.



Figure 1. The Node distribution dialog.
Distribution Mode
Nodes can be distributed either using a fixed number of nodes, a homogeneous distribution density or based on a land usage map in combination with a distribution table.
Fixed number
Fixed number of nodes, which shall be distributed. This value is only relevant if “Fixed number of nodes” is selected for the distribution mode
Density
For the homogeneous distribution a fixed density value, thus the average number of nodes per square kilometer, has to be specified. This value is only relevant if Homogeneous with fixed density is selected for the Distribution Mode.
Distribution Table
In case the project contains land usage data, the distribution can be done clutter specific using a distribution table, which defines the distribution densities for the relevant clutter classes individually. 
If a distribution table is already available, the file can be browsed for using the Browse button. The Create / Edit Distribution Table button offers the possibility to create a new table or to edit the already specified one. By pressing this button, the dialog shown below opens and displays the current content of the selected distribution table.


Figure 2. The Distribution Table dialog.
Add
Create a new distribution class using the Distribution Class dialog shown below.
Edit
Modify an already existing distribution class using the Distribution Class dialog shown below.
Delete
Remove one or several selected distribution classes from the table.

A distribution class can be created or edited with the dialog depicted below.



Figure 3. The Distribution Class dialog.
Name
Arbitrary name of the defined distribution class.
Density
Fixed density value, thus the average number of nodes per square kilometer for this distribution class.
Clutter Classes
Clutter classes contained in the clutter database of the project can be assigned to the distribution class. Therefore the drop-down list on the right-hand side contains all available clutter classes which have not been assigned yet. By selecting a clutter class and pressing the Add button, the defined distribution settings are considered in the area of the selected clutter class. Selected clutter classes can be removed from the distribution class by pressing the Delete button. If the option “Colorize Clutter Classes” is enabled, the list entries are displayed with the color of the corresponding clutter class.
Distribution Area
The area which shall be considered for the distribution can be specified with its lower-left and upper-right corner coordinates. By pressing the Reset button, the coordinates are set in order to obtain the maximum possible distribution area.
Node
Template
The general parameters of the nodes to be created can be specified with a template node. The available templates are contained in the Component Catalogue, which can be directly accessed by pressing the Edit button.
Height
The height of the nodes above ground level has to be specified in meters.
Channel ID
The drop-down list contains the available channel IDs of the channels defined on the Channel tab of the System Configuration dialog. The selected channel ID will be assigned to all created nodes.