Perform DOE

In this step, DOE method will allocate each .h3d file to its respective run folder. The dataset will allow visualization of stress contour change through a set of design points.

  1. Add a DOE.
    1. In the Explorer, right-click and select Add from the context menu.
      The Add dialog opens.
    2. Select DOE.
    3. For Definition from, select Setup approach and click OK.
  2. Go to the DOE > Specifications step.
  3. In the work area, set the Mode to Modified Extensible Lattice Sequence (any available DOE method should work as dataset is obtained elsewhere which renders sampling scheme irrelevant) and in the Settings tab of the Channel selector, the number of runs is set to 5 by default, equal to the number of .h3d files.
  4. Click Apply.
  5. Go to the DOE > Evaluate step.
  6. Click Evaluate Tasks.
  7. Go to the DOE > Post-Processing step.
  8. Review media result.
    1. Click the Media tab.
    2. Select all the runs in the Channel Selector to visualize results side-by-side.
      Note: Make sure is active, otherwise results are displayed one at a time.
    Figure 1.