Cp (Time-Averaged)
-
From the Post ribbon, click on the Slice Planes Tool.
The Slice Planes Guide Bar opens.
-
Click on the Z-Plane.
The Slice Plane Micro-Dialog opens.
- From the Slice Plane Micro-Dialog, check Finite slice, then expand the Micro-Dialog by clicking on the Fold Frame button on the top-right corner and set the Length and Width to 9 and 3 respectively.
-
From the Slice Plane Micro-Dialog, press the Show Vector Tool button.
Figure 1. 
The Vector Tool opens. - From the Vector Tool, press the Show Handle Coordinates button (XYZ) to toggle to the handle coordinates inputs as shown in Figure 29.
-
Set the Z-Coordinate to 0.368879.
Note: The value of 0.368879 pertains to the z-midpoint of the front-left tire. You may calculate this value from the data contained in Wheel_Tire_Front_Left.csv, which was created following the steps in the Save Boundary Information section.
- Middle-click to accept the changes.
- Repeat Steps 6-11.
- From the Post Browser, under Standard Output > Visualizations > Slice Planes, right click on the newly created Slice Plane and rename to Z-Slice Front Axle Center.
- From the Post Browser, under Standard Output > Visualizations > Clips, right click on Y-Clip Vehicle Front Axle Center | Right and click Show.
- Cycle through the Wake | Left , Left | Front, and Wake | Left | Rear views and capture images for each.