List of fixed issues

1. All machines

  1. Tests with the solid conductors in slots - Current in parallel paths is wrong

    While computing a working point with elementary wires modeled with solid conductors, the computed electrical current in the branches in parallel is wrong if the following conditions are met (ref.: FXM-14728):

    There are parallel paths,

    The “Accurate mode” of computation is selected

    The “AC losses analysis” in “One” or “All phases” is selected

    The resulting finite element model doesn’t represent the full geometry

    This issue has been corrected.

  2. Building and export of a report failed

    While adding multiple new tests, and simultaneously executing the previously saved tests (12) along with assigning material in the report and saved test (12) + Materials in the report, the building and the export of the resulting report can fail (ref.: FXM-11574) + (ref.: FXM-14117).

    Note: In that case it is recommended to increase the allocated memory for Motor Factory in the user’s preferences.

    These issues have been corrected. (à verifier!!!)

  3. Inner slots with 2 layers winding and a liner can be infeasible

    Rarely, while adding a liner inside an inner slot inside of which there are 2 layers can fail (ref.: FXM-14100).

    This issue has been corrected.

  4. Issue with report generation

    Sometimes, the report generation freezes

    This is mainly due to the management of memory. An increase in the allocated memory for Motor Factory can solve the problem (ref.: FXM-13585).

    This issue has been corrected.

  5. Save motor doesn’t work

    Sometimes, saving a motor doesn’t work.

    This is mainly due to the management of memory. Increasing the allocated memory for Motor Factory can solve the problem (ref.: FXM-13584).

    This issue has been corrected.

2. Synchronous machines – Motor Factory – Test environment

  1. Duty cycle with many working points fails

    Run a computation of a duty cycle with many working points via scripting crashes (ref.: FXM-14435).

    This issue has been corrected.

  2. FMU LuT data Export: Flux_D and Flux_Q are incorrect

    The flux linkage related to the end winding inductances on FMU side is not considered as it is done on the test map side (ref.: FXM-14041).

    This issue has been corrected.