Calibration factors
1. Overview  Definitions
Label  Symbol  Tooltip, note, formula 
Resistance factor  *  Setting of the “Resistance factor”: It allows modifying the computation
result of resistance. Thus, the resulting phase resistance value is considered. 
Inductance factor  *  Setting of the “Inductance factor”. It allows modifying the computation
result of endwinding inductance. Thus, the resulting endwinding inductance value is considered. 
Ref. temperature  *  The reference temperature: First, the resistance values are computed by
considering a temperature equal to 20°C. However, the user can also define his own reference temperature to compute the corresponding phase resistance and LineLine resistance values. Note: This reference temperature is used only in the
winding design environment.The test temperatures are defined in the test
settings (refer to TEST chapter).

2. Illustrations


Building the winding – XFactor = Calibration factors  
1  Selection of the XFACTOR section. 
2  Setting of the “Resistance factor”. It allows adjusting computation
result of resistance. Thus, the resulting phase resistance value is considered. 
3  Setting of the “Inductance factor”. It allows modifying the computation
result of endwinding inductance. Thus, the resulting endwinding inductance value is considered. 
4  The reference temperature: First, resistance values are computed by considering a temperature equal to 20°C (5). However, the users can also define their own reference temperature to compute the corresponding phase resistance and LineLine resistance values. 
5  Resistance values for a reference temperature equal to 20°C. 