Target Category: Linux AMD64 and Raspberry Pi
The Linux Config lets you configure the settings for the AMD64 and Raspberry Pi. After you enter the settings, a Linux Config block is inserted into the diagram.
Linux Config uses TCP/IP to connect to an AMD64 or Raspberry Pi device. A daemon runs on the Raspberry Pi for this purpose. The Linux Config uses these ports:
|
Protocol |
Port |
|
TCP |
50009 57893 |
|
UDP |
50002 50003 57892 |
CPU: Sets the CPU type for the Raspberry Pi or AMD64.
CPU Speed: Indicates the speed of the CPU.
Diagram Task Priority: Sets the Linux priority of diagram task execution. Specify the priority as an integer in the range of 1 – 99, where 1 is the highest priority.
Idle Loop Priority: Sets the Linux priority of idle loop execution. Specify the priority as an integer in the range of 1 – 99, where 1 is the highest priority.
Network Interface: Chooses the network interface.
Refresh: Reloads the current IP of the host machine and connected Raspberry Pi or AMD64.
Target IPs: Chooses the IP of the connected Raspberry Pi or AMD64.
Target OS: Chooses the operating system of the connected Raspberry Pi or AMD64. Supported operating systems for Raspberry Pi are Buster and Stretch; the supported operating system for AMD64 is Xenial Xerus.